startTime=0 stopTime=1500 tolerance=1e-06 numberOfIntervals=1000 stepSize=1.5 wasm artifact (cs: FMI 3.0 Co-Simulation, the artifact integrating itself with DASKR): simulate(ThermofluidStream.Examples.EspressoMachine,startTime=0,stopTime=1500,tolerance=1e-06,numberOfIntervals=1000,outputFormat="mat",variableFilter="PI.x|PID1.I.y|PID2.I.y|PID3.I.y|Tasse.sink.inlet.m_flow|Tasse.x|Tasse1.x|Time|boiler.phaseSeparator2_1.M|boiler.phaseSeparator2_1.U_med|brewing_head.T|conductionElement1.h|espressoValve.T_start|espressoValve.count|firstOrder1.y|firstOrder2.y|firstOrder3.y|firstOrder7.y|hex.M|hex.U_med|hex.m_flow_in|hex.m_flow_out|pump.m_flow|pump1.m_flow|steamSink1.x|steam_valve.T_start|steam_valve.count|steam_valve1.T_start|steam_valve1.count|tanValve1.inlet.m_flow|tanValve6.inlet.m_flow|waterSink.x",fileNamePrefix="ThermofluidStream_dev_ThermofluidStream.Examples.EspressoMachine",simflags=" -alarm=240 -emit_protected -lv LOG_STATS -startTime=0 -stopTime=1500 -tolerance=1e-06 -stepSize=1.5 -r=ThermofluidStream_dev_ThermofluidStream.Examples.EspressoMachine_cs_res.mat -s fmi3:cs",resimulateExecutable="ThermofluidStream_dev_ThermofluidStream_Examples_EspressoMachine.fmu") LOG_STDOUT | info | wasm artifact loaded in 0.2 ms (model kernel linked against the cached adapter, 0.9 MB) LOG_STDOUT | warning | The default linear solver fails, the fallback solver with total pivoting is started at time 0.000000. That might raise performance issues, for more information use -lv LOG_LS. LOG_STDOUT | warning | While solving non-linear system an assertion failed at time 1141.37. | | | | | The non-linear solver tries to solve the problem that could take some time. | | | | | It could help to provide better start-values for the iteration variables. | | | | | For more information simulate with -lv LOG_NLS_V LOG_STDOUT | info | CoSimulation instantiated in 0.7 ms LOG_STDOUT | info | CoSimulation run: 1056 communication steps, 56 events, 56 early returns, 1113 samples in 7983.8 ms LOG_SUCCESS | info | The simulation finished successfully.