(cd run_OMSimulator-cs-cvode && /home/hudson/saved_omc/OMSimulator/install/bin/OMSimulator --stripRoot --tempDir=temp_HanserModelica_HanserModelica_Electrical_TablesFromFile_OMSimulator-cs-cvode_fmu --startTime=0 --stopTime=4 --stepSize=0.001 --mode=cs --timeout=240 --tolerance=1e-06 ../HanserModelica_HanserModelica_Electrical_TablesFromFile_OMSimulator-cs-cvode.fmu) LOG_SOLVER | info | CVODE linear multistep method CV_BDF LOG_SOLVER | info | CVODE maximum integration order CV_ITER_NEWTON LOG_SOLVER | info | CVODE use equidistant time grid YES LOG_SOLVER | info | CVODE Using relative error tolerance 1.000000e-06 LOG_SOLVER | info | CVODE Using dense internal linear solver SUNLinSol_Dense. LOG_SOLVER | info | CVODE Use internal dense numeric jacobian method. LOG_SOLVER | info | CVODE uses internal root finding method NO LOG_SOLVER | info | CVODE maximum absolut step size 0 LOG_SOLVER | info | CVODE initial step size is set automatically LOG_SOLVER | info | CVODE maximum integration order 5 LOG_SOLVER | info | CVODE maximum number of nonlinear convergence failures permitted during one step 10 LOG_SOLVER | info | CVODE BDF stability limit detection algorithm OFF info: *** FMU Simulation Info *** - model : HanserModelica.Electrical.TablesFromFile (co-simulation) - fmiVersion: 2.0 - startTime : 0.000000 - stopTime : 4.000000 - tolerance : 1e-06 - stepSize : 0.001 LOG_STDOUT | info | ... loading "resistor" from "/tmp/tmp6mkc3hk9/TablesFromFile-p6k2n2vo/temp/0001_TablesFromFile/resources/home/hudson/saved_omc/libraries/.openmodelica/libraries/HanserModelica 2.0.1/Resources/Tables/table.txt" info: Result file: HanserModelica_HanserModelica_Electrical_TablesFromFile_OMSimulator-cs-cvode_res.mat (bufferSize=10) info: Parameter TablesFromFile.table.delimiter will not be stored in the result file, because the signal type is not supported info: Variable TablesFromFile.table.fileName will not be stored in the result file, because the signal type is not supported info: Parameter TablesFromFile.table.tableName will not be stored in the result file, because the signal type is not supported