/home/hudson/saved_omc/OMSimulator/install/bin/OMSimulator -r=Buildings_10_Buildings.Fluid.FMI.Validation.HeaterFan_res.mat --tempDir=temp_Buildings_10_Buildings_Fluid_FMI_Validation_HeaterFan_fmu --startTime=0 --stopTime=1 --timeout=400 --tolerance=1e-06 Buildings_10_Buildings_Fluid_FMI_Validation_HeaterFan.fmu
info:    model doesn't contain any continuous state
LOG_ASSERT        | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/Buildings 10.1.1-maint.10.0.x/Fluid/Movers/BaseClasses/PartialFlowMachine.mo:389:3-396:39:writable]
|                 | |       | The following assertion has been violated during initialization at time 0.000000
|                 | |       | ((false)) --> "*** Warning in HeaterFan.floMac.com: Mover is flow or pressure controlled and uses default pressure curve.
|                 | |       | This leads to an approximate power consumption.
|                 | |       | Set nominalValuesDefineDefaultPressureCurve=true to suppress this warning."
LOG_ASSERT        | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/Buildings 10.1.1-maint.10.0.x/Fluid/Movers/BaseClasses/PartialFlowMachine.mo:417:3-427:39:writable]
|                 | |       | The following assertion has been violated during initialization at time 0.000000
|                 | |       | ((false)) --> "*** Warning in HeaterFan.floMac.com: Mover has per.etaHydMet=.Power_VolumeFlowRate or per.etaHydMet=.EulerNumber.
|                 | |       | This requires per.pressure to be provided.
|                 | |       | Because it is not, the model overrides this setting by using per.etaHydMet=.NotProvided.
|                 | |       | Also consider using models under Movers.Preconfigured which autopopulate a pressure curve."
LOG_ASSERT        | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/Buildings 10.1.1-maint.10.0.x/Fluid/Movers/BaseClasses/PartialFlowMachine.mo:429:3-439:39:writable]
|                 | |       | The following assertion has been violated during initialization at time 0.000000
|                 | |       | ((false)) --> "*** Warning in HeaterFan.floMac.com: Mover has per.etaMotMet=.Efficiency_MotorPartLoadRatio or per.etaMotMet=.GenericCurve.
|                 | |       | This requires per.WMot_nominal or per.pressure to be provided. Because neither is provided,
|                 | |       | the model overrides this setting and by using per.etaMotMet=.NotProvided.
|                 | |       | Also consider using models under Movers.Preconfigured which autopopulate a pressure curve."
info:    Result file: Buildings_10_Buildings.Fluid.FMI.Validation.HeaterFan_res.mat (bufferSize=1)