python3 -m fmpy simulate  --output-file IDEAS_dev_IDEAS.Fluid.Actuators.Valves.Simplified.Examples.Thermostatic3WayValve_res.csv --start-time 0 --stop-time 15 --timeout 50 --relative-tolerance 1e-06 --interface-type ModelExchange --solver CVode --output-interval 0.006 IDEAS_dev_IDEAS_Fluid_Actuators_Valves_Simplified_Examples_Thermostatic3WayValve.fmu
LOG_STDOUT        | info    | 
|                 | |       | Warning:
|                 | |       | ========
|                 | |       | It is recommended that the volume flow rate versus pressure relation
|                 | |       | of the fan or pump satisfies the minimum decrease condition
|                 | |       | 
|                 | |       |         (per.pressure.dp[i+1]-per.pressure.dp[i])
|                 | |       | d[i] = ------------------------------------------------- < -0
|                 | |       |        (per.pressure.V_flow[i+1]-per.pressure.V_flow[i])
|                 | |       | 
|                 | |       |  is
|                 | |       |   d[1]=0     
|                 | |       | 
|                 | |       | Otherwise, a solution to the equations may not exist if the fan or pump speed is reduced.
|                 | |       | In this situation, the solver will fail due to non-convergence and
|                 | |       | the simulation stops.
LOG_ASSERT        | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/IDEAS 3.0.0-master/Fluid/Movers/BaseClasses/PartialFlowMachine.mo:348:3-357:39:writable]
|                 | |       | The following assertion has been violated during initialization at time 0.000000
|                 | |       | ((pump.nominalValuesDefineDefaultPressureCurve)) --> "*** Warning: You are using a flow or pressure controlled mover with the
|                 | |       |              default pressure curve.
|                 | |       |              This leads to approximate calculations of the electrical power
|                 | |       |              consumption. Add the correct pressure curve in the record per
|                 | |       |              to obtain an accurate computation.
|                 | |       |              Setting nominalValuesDefineDefaultPressureCurve=true will suppress this warning."