python3 -m fmpy simulate --output-file IDEAS_IDEAS.Buildings.Validation.Tests.n50Test3_res.csv --start-time 0 --stop-time 3 --timeout 50 --relative-tolerance 1e-06 --interface-type ModelExchange --solver CVode --output-interval 0.0012 IDEAS_IDEAS_Buildings_Validation_Tests_n50Test3.fmu LOG_ASSERT | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/IDEAS 3.0.0/Buildings/Components/BaseClasses/RadiativeHeatTransfer/ZoneLwDistribution.mo:84:3-89:34:writable] | | | | The following assertion has been violated during initialization at time 0.000000 | | | | ((max(zone1.radDistrLw.F1) < zone1.radDistrLw.FMax * 0.9 and zone1.radDistrLw.computeCarroll or zone1.radDistrLw.simVieFac)) --> "WARNING: In n50Test3.zone1.radDistrLw: The computed view factor returned unexpected results. | | | | A simplified method is used. | | | | This may be caused by trying to model a non-physical geometry. | | | | Avoid this warning by setting simVieFac=true in the respective zone model. | | | | " LOG_ASSERT | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/IDEAS 3.0.0/Buildings/Components/BaseClasses/RadiativeHeatTransfer/ZoneLwGainDistribution.mo:93:3-93:225:writable] | | | | The following assertion has been violated during initialization at time 0.000000 | | | | ((zone1.radDistr.AfloorTot > 2e-60)) --> "In n50Test3.zone1.radDistr: Zone does not contain a floor surface so incoming beam radiation is spread over all other surfaces! Is this intended? | | | | " LOG_ASSERT | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/IDEAS 3.0.0/Buildings/Components/BaseClasses/RadiativeHeatTransfer/ZoneLwDistribution.mo:84:3-89:34:writable] | | | | The following assertion has been violated during initialization at time 0.000000 | | | | ((max(zone.radDistrLw.F1) < zone.radDistrLw.FMax * 0.9 and zone.radDistrLw.computeCarroll or zone.radDistrLw.simVieFac)) --> "WARNING: In n50Test3.zone.radDistrLw: The computed view factor returned unexpected results. | | | | A simplified method is used. | | | | This may be caused by trying to model a non-physical geometry. | | | | Avoid this warning by setting simVieFac=true in the respective zone model. | | | | "