python3 -m fmpy simulate  --output-file Buildings_9_Buildings.Fluid.HeatExchangers.DXCoils.WaterCooled.Validation.VariableSpeedEnergyPlusPartLoad_res.csv --start-time 0 --stop-time 86400 --timeout 50 --relative-tolerance 1e-06 --interface-type ModelExchange --solver CVode --output-interval 34.56 Buildings_9_Buildings_Fluid_HeatExchangers_DXCoils_WaterCooled_Validation_VariableSpeedEnergyPlusPartLoad.fmu
LOG_NLS           | error   | residualFunc1210: Iteration variable xloc[2] is nan.
LOG_ASSERT        | debug   | residualFunc1210 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_STDOUT        | warning | While solving non-linear system an assertion failed during initialization.
|                 | |       | | The non-linear solver tries to solve the problem that could take some time.
|                 | |       | | It could help to provide better start-values for the iteration variables.
|                 | |       | | For more information simulate with -lv LOG_NLS_V
LOG_NLS           | error   | residualFunc1210: Iteration variable xloc[6] is nan.
LOG_ASSERT        | debug   | residualFunc1210 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_NLS           | error   | residualFunc1210: Iteration variable xloc[2] is nan.
LOG_ASSERT        | debug   | residualFunc1210 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_NLS           | error   | residualFunc1210: Iteration variable xloc[2] is nan.
LOG_ASSERT        | debug   | residualFunc1210 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | warning | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/Buildings 9.1.3-maint.9.1.x/Fluid/HeatExchangers/DXCoils/BaseClasses/Evaporation.mo:185:3-194:27:writable]
|                 | |       | The following assertion has been violated during initialization at time 0.000000
|                 | |       | ((varSpeDX.eva.eva.nomVal.gamma <= varSpeDX.eva.eva.gammaMax)) --> "*** Warning: In DX coil model, gamma is too large for these coil conditions.
|                 | |       |     Instead of gamma = 1.5, a value of 0.346977, which
|                 | |       |     corresponds to a mass transfer effectiveness of 0.8, will be used.
|                 | |       |     Coil nominal performance data are:
|                 | |       |     nomVal.m_flow_nominal = 0.462462
|                 | |       |     dX_nominal = XEvaOut_nominal-XEvaWetBulOut_nominal = 0.00571197 - 0.00634552 = -0.000633544
|                 | |       |     QLat_flow_nominal  = -1689.5
|                 | |       | "