OMSimulator --tempDir=temp_Buildings_6_0_0_Buildings_Experimental_DistrictHeatingCooling_SubStations_Validation_HeatingSubstation_fmu --startTime=0 --stopTime=86400 --timeout=50 --tolerance=1e-06 Buildings_6_0_0_Buildings_Experimental_DistrictHeatingCooling_SubStations_Validation_HeatingSubstation.fmu info: Set temp directory to "/tmp/omsimulator" info: Set working directory to "." info: New temp directory has been created: "temp_Buildings_6_0_0_Buildings_Experimental_DistrictHeatingCooling_SubStations_Validation_HeatingSubstation_fmu" info: Set temp directory to "/var/lib/jenkins/ws/OpenModelicaLibraryTestingWork/OpenModelicaLibraryTesting/Buildings_6.0.0_Buildings.Experimental.DistrictHeatingCooling.SubStations.Validation.HeatingSubstation/temp_Buildings_6_0_0_Buildings_Experimental_DistrictHeatingCooling_SubStations_Validation_HeatingSubstation_fmu" info: Set working directory to "/var/lib/jenkins/ws/OpenModelicaLibraryTestingWork/OpenModelicaLibraryTesting/Buildings_6.0.0_Buildings.Experimental.DistrictHeatingCooling.SubStations.Validation.HeatingSubstation" info: New model "model" with corresponding temp directory "/var/lib/jenkins/ws/OpenModelicaLibraryTestingWork/OpenModelicaLibraryTesting/Buildings_6.0.0_Buildings.Experimental.DistrictHeatingCooling.SubStations.Validation.HeatingSubstation/temp_Buildings_6_0_0_Buildings_Experimental_DistrictHeatingCooling_SubStations_Validation_HeatingSubstation_fmu/model-smhufgdu" info: model doesn't contain any continuous state warning: fmu (logStatusWarning): /var/lib/jenkins/ws/OpenModelicaLibraryTestingWork/OMCompiler/build/lib/omlibrary/Buildings 6.0.0/Fluid/Movers/BaseClasses/PartialFlowMachine.mo:352: The following assertion has been violated during initialization at time 0.000000 subSta.pum.nominalValuesDefineDefaultPressureCurve assert | warning | *** Warning: You are using a flow or pressure controlled mover with the | | | | default pressure curve. | | | | This leads to approximate calculations of the electrical power | | | | consumption. Add the correct pressure curve in the record per | | | | to obtain an accurate computation. | | | | Setting nominalValuesDefineDefaultPressureCurve=true will suppress this warning. info: Result file: model_res.mat (bufferSize=10) info: 1 warnings info: 0 errors