startTime=0 stopTime=1 tolerance=1e-06 numberOfIntervals=1000 stepSize=0.001 wasm-jit simulation: simulate(ThermofluidStream.Processes.Tests.ConductionElement,startTime=0,stopTime=1,tolerance=1e-06,numberOfIntervals=1000,outputFormat="mat",variableFilter="Time|conductionElement.h|conductionElement1.deltaE_system|conductionElement1.h|conductionElement1.inlet.m_flow|conductionElement2.h|conductionElement2.inlet.m_flow|conductionElement3.deltaE_system|conductionElement3.h|conductionElement4.h|sink.inlet.m_flow|source1.outlet.m_flow|source2.outlet.m_flow",fileNamePrefix="ThermofluidStream_ThermofluidStream.Processes.Tests.ConductionElement",simflags="-abortSlowSimulation -alarm=240 -emit_protected -lv LOG_STATS") LOG_SUCCESS | info | The initialization finished successfully without homotopy method. LOG_ASSERT | info | [/home/hudson/saved_omc/libraries/.openmodelica/libraries/ThermofluidStream 1.4.1/Processes/Internal/PartialConductionElement.mo:56:3-56:143:writable] | | | | The following assertion has been violated at time 0.001000 | | | | ((noEvent(conductionElement3.inlet.m_flow > conductionElement3.m_flow_assert))) --> "In "ConductionElement.conductionElement3": Negative mass flow rate at inlet" LOG_STATS | info | ### STATISTICS ### | | | | | timer | | | | | | 0s reading init.xml | | | | | | 0s reading info.xml | | | | | | 3.8401e-05s [ 0.6%] pre-initialization | | | | | | 7.9798e-05s [ 1.2%] initialization | | | | | | 0s [ 0.0%] steps | | | | | | 0.000504596s [ 7.5%] solver (excl. callbacks) | | | | | | 0.000153174s [ 2.3%] creating output-file | | | | | | 0.000283562s [ 4.2%] event-handling | | | | | | 0s [ 0.0%] overhead | | | | | | 0.00565741s [ 84.2%] simulation | | | | | | 0.00671694s [100.0%] total | | | | | events | | | | | | 0 state events | | | | | | 2 time events | | | | | solver: dassl | | | | | | 261 steps taken | | | | | | 330 calls of functionODE | | | | | | 82 evaluations of jacobian | | | | | | 6 error test failures | | | | | | 0 convergence test failures | | | | | | 0.000674479s time of jacobian evaluation LOG_SUCCESS | info | The simulation finished successfully.