OMSimulator --tempDir=temp_IDEAS_IDEAS_Fluid_FMI_Validation_HeaterFan_fmu --startTime=0 --stopTime=1 --timeout=50 --tolerance=1e-06 IDEAS_IDEAS_Fluid_FMI_Validation_HeaterFan.fmu info: Set temp directory to "/tmp/omsimulator" info: Set working directory to "." info: New temp directory has been created: "temp_IDEAS_IDEAS_Fluid_FMI_Validation_HeaterFan_fmu" info: Set temp directory to "/var/lib/jenkins1/ws/OpenModelicaLibraryTestingWork/OpenModelicaLibraryTesting/IDEAS_IDEAS.Fluid.FMI.Validation.HeaterFan/temp_IDEAS_IDEAS_Fluid_FMI_Validation_HeaterFan_fmu" info: Set working directory to "/var/lib/jenkins1/ws/OpenModelicaLibraryTestingWork/OpenModelicaLibraryTesting/IDEAS_IDEAS.Fluid.FMI.Validation.HeaterFan" info: New model "model" with corresponding temp directory "/var/lib/jenkins1/ws/OpenModelicaLibraryTestingWork/OpenModelicaLibraryTesting/IDEAS_IDEAS.Fluid.FMI.Validation.HeaterFan/temp_IDEAS_IDEAS_Fluid_FMI_Validation_HeaterFan_fmu/model-z6nnmk6i" info: model doesn't contain any continuous state warning: fmu (logStatusWarning): /home/hudson/saved_omc/libraries/.openmodelica/libraries/IDEAS 3.0.0-master/Fluid/Movers/BaseClasses/PartialFlowMachine.mo:348: The following assertion has been violated during initialization at time 0.000000 false assert | warning | *** Warning: You are using a flow or pressure controlled mover with the | | | | default pressure curve. | | | | This leads to approximate calculations of the electrical power | | | | consumption. Add the correct pressure curve in the record per | | | | to obtain an accurate computation. | | | | Setting nominalValuesDefineDefaultPressureCurve=true will suppress this warning. info: Result file: model_res.mat (bufferSize=10) info: 1 warnings info: 0 errors