startTime=0
stopTime=7
tolerance=1e-06
numberOfIntervals=5006
stepSize=0.00139832
wasm-jit simulation: simulate(ModelicaTest.Fluid.TestComponents.Machines.TestControlledPump,startTime=0,stopTime=7,tolerance=1e-06,numberOfIntervals=5006,outputFormat="mat",variableFilter="time|massFlowRate.y|sink.ports.[0-9,]+..m_flow|sink.ports.[0-9,]+..p|sink.ports.[0-9,]+..h_outflow|pump.port_b.m_flow|pump.port_b.p|pump.port_b.h_outflow|valve.port_b.m_flow|valve.port_b.p|valve.port_b.h_outflow|valve.minLimiter.y|valveOpening.y|pressure1.y|sink1.ports.[0-9,]+..m_flow|sink1.ports.[0-9,]+..p|sink1.ports.[0-9,]+..h_outflow|pump1.port_b.m_flow|pump1.port_b.p|pump1.port_b.h_outflow|valve1.port_b.m_flow|valve1.port_b.p|valve1.port_b.h_outflow|valve1.minLimiter.y|valveOpening1.y|sinkPressure.y",fileNamePrefix="ModelicaTest_4.1.0_ModelicaTest.Fluid.TestComponents.Machines.TestControlledPump",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: ModelicaTest.Fluid.TestComponents.Machines.TestControlledPump
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 0 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | No solution for current step size tau found and tau cannot be decreased any further.
|                 | |       | You can set the minimum step size tau with:
|                 | |       |   -homTauMin=<value>
|                 | |       | You can also try to allow more newton steps in the corrector step with:
|                 | |       |   -homMaxNewtonSteps=<value>
|                 | |       | or change the tolerance for the solution with:
|                 | |       |   -homHEps=<value>
|                 | |       | You can also try to use another backtrace stategy in the corrector step with:
|                 | |       |   -homBacktraceStrategy=<fix|orthogonal>
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | lambda is smaller than -1: lambda=-1.20597
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 130 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization