startTime=0
stopTime=3600
tolerance=1e-05
numberOfIntervals=2500
stepSize=1.44
wasm-jit simulation: simulate(ClaRa.Components.HeatExchangers.Check.Test_HEXvle2vle_L3_2ph_CH_ntu,startTime=0,stopTime=3600,tolerance=1e-05,numberOfIntervals=2500,outputFormat="mat",variableFilter="PI.I.y|PI.resetValueI|PI.resetValueID|PI.resetValueP|PI.smoothPIDInput.y_aux|PI.smoothPIDOutput.y_aux|PI.smoothPIDOutput1.y_aux|Time|hex.shell.h_liq|hex.shell.h_vap|hex.shell.p_vap|hex.shell.volume_vap|hex.tubes.h|hex.tubes.p|hex.wall.PI_1ph_in.outputI|hex.wall.PI_2ph.outputI|hex.wall.nTU.Q_flow_s.[0-9,]+.|hex.wall.nTU.T_w_i.[0-9,]+.|hex.wall.nTU.T_w_o.[0-9,]+.|hex.wall.nTU.yps.[0-9,]+.",fileNamePrefix="ClaRa_dev_ClaRa.Components.HeatExchangers.Check.Test_HEXvle2vle_L3_2ph_CH_ntu",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: ClaRa.Components.HeatExchangers.Check.Test_HEXvle2vle_L3_2ph_CH_ntu
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 0 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | No solution for current step size tau found and tau cannot be decreased any further.
|                 | |       | You can set the minimum step size tau with:
|                 | |       |   -homTauMin=<value>
|                 | |       | You can also try to allow more newton steps in the corrector step with:
|                 | |       |   -homMaxNewtonSteps=<value>
|                 | |       | or change the tolerance for the solution with:
|                 | |       |   -homHEps=<value>
|                 | |       | You can also try to use another backtrace stategy in the corrector step with:
|                 | |       |   -homBacktraceStrategy=<fix|orthogonal>
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | lambda is smaller than -1: lambda=-1.4
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 501 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization