startTime=0
stopTime=50000
tolerance=1e-05
numberOfIntervals=2500
stepSize=20
wasm-jit simulation: simulate(ClaRa.Components.Control.PredictorModels_3508.Check.TestPredictor,startTime=0,stopTime=50000,tolerance=1e-05,numberOfIntervals=2500,outputFormat="mat",variableFilter="HPTurbine.getInputsRotary.shaft_a.phi|IPTurbine.getInputsRotary.shaft_a.phi|LPTurbine.getInputsRotary.shaft_a.phi|Model_boiler.SteamStorage.y|Model_boiler.enthalpyPredictor.firstOrder.y|Model_boiler.enthalpyPredictor.firstOrder1.y|Model_boiler.enthalpyPredictor.firstOrder2.y|Model_boiler.enthalpyPredictor.firstOrder3.y|Model_boiler.heatRelease.x_scaled.[0-9,]+.|PID.I.y|PID.resetValueI|PID.resetValueID|PID.resetValueP|PID.smoothPIDInput.y_aux|PID.smoothPIDOutput.y_aux|PID.smoothPIDOutput1.y_aux|Time|scope.u_in|split.h|split.p|steamGenerator.h_HP|steamGenerator.h_IP|steamGenerator.heatRelease.x_scaled.[0-9,]+.|steamGenerator.p_HP|steamGenerator.p_IP|turbinesAndReheat_01.energyStorage_HP_turbine.y|turbinesAndReheat_01.energyStroage_RH_IPLP_turbine.y",fileNamePrefix="ClaRa_dev_ClaRa.Components.Control.PredictorModels_3508.Check.TestPredictor",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: ClaRa.Components.Control.PredictorModels_3508.Check.TestPredictor
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 0 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | The system is singular and not solvable.
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | The system is singular and not solvable.
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 231 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization