startTime=0
stopTime=15000
tolerance=1e-06
numberOfIntervals=15019
stepSize=0.998735
wasm-jit simulation: simulate(ClaRa.Components.Sensors.Check.TestSensorVLE_L3_T,startTime=0,stopTime=15000,tolerance=1e-06,numberOfIntervals=15019,outputFormat="mat",variableFilter="Time|temperatureSensorVLE_L3.fluidVolume.h|temperatureSensorVLE_L3.fluidVolume.p|temperatureSensorVLE_L3.pipeWall.U.[0-9,]+.|temperatureSensorVLE_L3.sensorWall.T.[0-9,]+.|temperatureSensorVLE_L3_considerHeatConduction.fluidVolume.h|temperatureSensorVLE_L3_considerHeatConduction.fluidVolume.p|temperatureSensorVLE_L3_considerHeatConduction.pipeWall.U.[0-9,]+.|temperatureSensorVLE_L3_considerHeatConduction.sensorWall.T.[0-9,]+.",fileNamePrefix="ClaRa_ClaRa.Components.Sensors.Check.TestSensorVLE_L3_T",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: ClaRa.Components.Sensors.Check.TestSensorVLE_L3_T
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 0 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | No solution for current step size tau found and tau cannot be decreased any further.
|                 | |       | You can set the minimum step size tau with:
|                 | |       |   -homTauMin=<value>
|                 | |       | You can also try to allow more newton steps in the corrector step with:
|                 | |       |   -homMaxNewtonSteps=<value>
|                 | |       | or change the tolerance for the solution with:
|                 | |       |   -homHEps=<value>
|                 | |       | You can also try to use another backtrace stategy in the corrector step with:
|                 | |       |   -homBacktraceStrategy=<fix|orthogonal>
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | lambda is smaller than -1: lambda=-1.2
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 293 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization