startTime=0
stopTime=10000
tolerance=1e-06
numberOfIntervals=2500
stepSize=4
wasm-jit simulation: simulate(ClaRa.Components.HeatExchangers.Check.Test_PlateHEXvle2vle_L3_2ph_ntu,startTime=0,stopTime=10000,tolerance=1e-06,numberOfIntervals=2500,outputFormat="mat",variableFilter="Time|plateHEX.flow_a.h|plateHEX.flow_b.h|plateHEX.thinWall.PI_1ph_in.outputI|plateHEX.thinWall.PI_2ph.outputI|plateHEX.thinWall.nTU.Q_flow_s.[0-9,]+.|plateHEX.thinWall.nTU.T_w_i.[0-9,]+.|plateHEX.thinWall.nTU.T_w_o.[0-9,]+.|plateHEX.thinWall.nTU.yps.[0-9,]+.",fileNamePrefix="ClaRa_ClaRa.Components.HeatExchangers.Check.Test_PlateHEXvle2vle_L3_2ph_ntu",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: ClaRa.Components.HeatExchangers.Check.Test_PlateHEXvle2vle_L3_2ph_ntu
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 0 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | The maximum number of lambda steps is reached (800).
|                 | |       | You can change the maximum number of lambda steps with:
|                 | |       |   -homMaxLambdaSteps=<value>
|                 | |       | You can also try to influence the step size tau with the following flags:
|                 | |       |   -homTauDecFac=<value>
|                 | |       |   -homTauDecFacPredictor=<value>
|                 | |       |   -homTauIncFac=<value>
|                 | |       |   -homTauIncThreshold=<value>
|                 | |       |   -homTauMax=<value>
|                 | |       |   -homTauMin=<value>
|                 | |       |   -homTauStart=<value>
|                 | |       | or you can also set the threshold for accepting the current bending with:
|                 | |       |   -homAdaptBend=<value>
|                 | |       | You can also try to use another backtrace stategy in the corrector step with:
|                 | |       |   -homBacktraceStrategy=<fix|orthogonal>
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | lambda is smaller than -1: lambda=-1.02384
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 287 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization