startTime=0
stopTime=9000
tolerance=1e-06
numberOfIntervals=2500
stepSize=3.6
wasm-jit simulation: simulate(Buildings.DHC.Plants.Cooling.Examples.StoragePlantDualSource,startTime=0,stopTime=9000,tolerance=1e-06,numberOfIntervals=2500,outputFormat="mat",variableFilter="time|pumSup1.m_flow|stoPla.revCon.m_flow|stoPla.pumPri.m_flow|stoPla.tanBra.mTan_flow|stoPla.revCon.pum.m_flow|stoPla.revCon.val.m_flow|ideUse1.yVal_actual|ideUse2.yVal_actual|ideUse3.yVal_actual|ideUse1.dp|ideUse2.dp|ideUse3.dp|stoPla.tanBra.heaPorTop.T|stoPla.tanBra.heaPorBot.T|stoPla.tanSta.y.[0-9,]+.",fileNamePrefix="Buildings_latest_Buildings.DHC.Plants.Cooling.Examples.StoragePlantDualSource",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: Buildings.DHC.Plants.Cooling.Examples.StoragePlantDualSource
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 0 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | No solution for current step size tau found and tau cannot be decreased any further.
|                 | |       | You can set the minimum step size tau with:
|                 | |       |   -homTauMin=<value>
|                 | |       | You can also try to allow more newton steps in the corrector step with:
|                 | |       |   -homMaxNewtonSteps=<value>
|                 | |       | or change the tolerance for the solution with:
|                 | |       |   -homHEps=<value>
|                 | |       | You can also try to use another backtrace stategy in the corrector step with:
|                 | |       |   -homBacktraceStrategy=<fix|orthogonal>
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | lambda is smaller than -1: lambda=-1.4
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 760 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization