startTime=0
stopTime=86400
tolerance=1e-06
numberOfIntervals=2500
stepSize=34.56
wasm-jit simulation: simulate(Buildings.DHC.Examples.Steam.SingleBoiler,startTime=0,stopTime=86400,tolerance=1e-06,numberOfIntervals=2500,outputFormat="mat",variableFilter="time|pla.QFue_flow|bld.[0-9,]+..Q_flow|pla.port_aSerHea.m_flow|bld.[0-9,]+..port_a.m_flow|pla.port_bSerHea.p|pla.port_aSerHea.p|bld.[0-9,]+..port_b.p|bld.[0-9,]+..sta_a.T|bld.[0-9,]+..sta_b.T|pla.port_aSerHea.h_outflow|pla.port_bSerHea.h_outflow|bld.[0-9,]+..port_a.h_outflow|bld.[0-9,]+..port_b.h_outflow|pla.conPum.u_s|pla.conPum.u_m|pla.conBoi.u_s|pla.conBoi.u_m|pla.conPum.y|pla.conBoi.y",fileNamePrefix="Buildings_12_Buildings.DHC.Examples.Steam.SingleBoiler",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: Buildings.DHC.Examples.Steam.SingleBoiler
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 0 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | No solution for current step size tau found and tau cannot be decreased any further.
|                 | |       | You can set the minimum step size tau with:
|                 | |       |   -homTauMin=<value>
|                 | |       | You can also try to allow more newton steps in the corrector step with:
|                 | |       |   -homMaxNewtonSteps=<value>
|                 | |       | or change the tolerance for the solution with:
|                 | |       |   -homHEps=<value>
|                 | |       | You can also try to use another backtrace stategy in the corrector step with:
|                 | |       |   -homBacktraceStrategy=<fix|orthogonal>
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | lambda is smaller than -1: lambda=-1.2
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 740 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization