startTime=0
stopTime=300
tolerance=1e-06
numberOfIntervals=2500
stepSize=0.12
wasm-jit simulation: simulate(Buildings.Fluid.HydronicConfigurations.ActiveNetworks.Examples.DiversionOpenLoop,startTime=0,stopTime=300,tolerance=1e-06,numberOfIntervals=2500,outputFormat="mat",variableFilter="time|ope.y.[0-9,]+.|pum.m_flow|con.val.m1_flow|con.val.m2_flow|con.val.m3_flow|mPum_flow_nominal|con.m2_flow_nominal|con1.val.m1_flow|con1.val.m2_flow|con1.val.m3_flow|con1.m2_flow_nominal|pum.dpMachine|dp.p_rel|dp1.p_rel|con.val.dp1|con1.val.dp1|loa.yLoa_actual|loa1.yLoa_actual",fileNamePrefix="Buildings_11_Buildings.Fluid.HydronicConfigurations.ActiveNetworks.Examples.DiversionOpenLoop",simflags="-abortSlowSimulation -alarm=240  -emit_protected -lv LOG_STATS")
Simulation execution failed for model: Buildings.Fluid.HydronicConfigurations.ActiveNetworks.Examples.DiversionOpenLoop
LOG_STDOUT        | warning | Sparsity pattern for non-linear system 4 is not regular. This indicates that something went wrong during sparsity pattern generation. Removing sparsity pattern and disabling NLS scaling.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | No solution for current step size tau found and tau cannot be decreased any further.
|                 | |       | You can set the minimum step size tau with:
|                 | |       |   -homTauMin=<value>
|                 | |       | You can also try to allow more newton steps in the corrector step with:
|                 | |       |   -homMaxNewtonSteps=<value>
|                 | |       | or change the tolerance for the solution with:
|                 | |       |   -homHEps=<value>
|                 | |       | You can also try to use another backtrace stategy in the corrector step with:
|                 | |       |   -homBacktraceStrategy=<fix|orthogonal>
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | info    | The homotopy algorithm is started again with opposing start direction.
LOG_ASSERT        | warning | Homotopy algorithm did not converge.
|                 | |       | lambda is smaller than -1: lambda=-1.16
|                 | |       | You can use -lv=LOG_INIT_HOMOTOPY,LOG_NLS_HOMOTOPY to get more information.
LOG_ASSERT        | debug   | Solving non-linear system 872 failed at time=0.
|                 | |       | For more information please use -lv LOG_NLS.
LOG_ASSERT        | info    | simulation terminated by an assertion at initialization